Quantity:
Total:
Total products:
Total shipping: To be determined
Tax: $0.00
Total:
Nooelec Ham It Down 3GHz Downconverter - Extends The Frequency of Your RTL-SDR or Radio to 3.1GHz! Receive UHF & L-Band Transmissions with Ease. TCXO, SMA Connectivity & Multiple Power Options Extend the frequency of your RTL-SDR, Software Defined Radio (SDR) or other radio up to 3.1GHz (3100MHz) with ease! Includes Ham It Down downconverter,...
Opera Cake is an antenna switching add-on board designed to sit directly on top of the HackRF One It has a recommended frequency range of 1MHz - 4GHz and is optimized for use as a single 1x8 switch, or as a pair of 1x4 switches Please note that this product is not physically compatible with the plastic enclosure sold with the HackRF, nor with the...
Tri-Band GSM/GPRS Module with AT-command support
GreatFET is a next generation GoodFET intended to serve as a custom Hi-Speed USB peripheral Includes 120 prototyping wires for your project!
bladeRF 2.0 micro xA4, 47MHz to 6GHz frequency range, 61.44MHz sampling rate, 2×2 MIMO channels USB 3.0 SuperSpeed Software Defined Radio.
bladeRF 2.0 micro xA9, 47MHz to 6GHz frequency range, 61.44MHz sampling rate, 2×2 MIMO channels USB 3.0 SuperSpeed Software Defined Radio. The xA9 features the largest-in-class 301KLE Cyclone V FPGA, an essential component for hardware accelerators and HDL signal processing chains including FFTs, Turbo Decoders, transmit modulators/filters, and receive...
Wideband and general purpose Tri-band Antenna.
Includes all necessary fitments and a carry case.
Bias-tee powered Power Amplifier (TX) for the bladeRF 2.0 micro
Bias-tee powered Low Noise Amplifier (RX) for the bladeRF 2.0 micro
The bladeRF x115 comes with a larger 115KLE Cyclone IV FPGA that provides additional room for hardware accelerators and signal processing chains including FFTs, Turbo Decoders, transmit modulators/filters, and receive acquisition correlators for burst modems.
The XB-200 is a block up-down converter that greatly expands the bladeRF’s usable frequency range down, making the platform suitable for HF/VHF applications. [Compatible only with bladeRF 1.0 x40 and x115]
